Accessories for Rheonics SRV Inline Viscometer simplify installation, mounting, calibration, and much more.
Mounting Plate
Mounting plate for open tank
AT-TT
Adapter Female G3/4″ – Male NPT 1/2”
EXT-TT
Extension tube
OR-TT
∅27×1.5 O-ring
CG-TT
Cable Gland NPT 1/2″
AB-TT
Adapter Female G3/4″ – Female NPT 1/2”
TOW-M12
M12 connector plyer
AD-ETH
Cable gland with Ethernet connector (for E1, E2)
CG-SME
Stainless Steel cable gland (for E1, E2)
OR-SME
SME sealing O-Ring (for E1, E2)
Power Supply
Power supply (for E1,E2,E3)
EX Connector
EX M12 straight cable connector
O-Rings are for adapters and accessories. SRV sensor probe does not use O-Ring seals.
OR-12G
Ø15.1×1.6 mm O-ring for G 1/2″ thread (HPT-12G, HAW)
OR-TMA
Ø29.82 x 2.62 mm O-Ring for TMA-34N
OR-TT
∅27×1.5 mm O-ring for SRV Teletube variant
OR-APC
∅42×2.5 mm O-Ring for APC accessory
FS-APC
∅30 x 2.5 mm Front Seal for APC acccessory
OR-SCC
∅16×2.5 mm O-Ring for Calibration Cylinder
You can expect the sensor on every station to measure and perform equally on any other station. The Rheonics SRV sensor is factory calibrated and traceable to NIST standards.
- Small Form Factor – Fits in your palm while more robust than any other inline viscometers!
- All 316L stainless steel wetted parts – Hermetically sealed, metal-metal process sealing – no elastomer
- Repeatable, Reproducible – Newtonian, non-Newtonian, Single and Multi-phase fluids
- Wide viscosity range – Air to 50,000+ cP
- Built-in fluid temperature measurement – Excellent thermal compensation to achieve consistency over the years
- No re-calibration needed – ever!
